control condition

英 [kənˈtrəʊl kənˈdɪʃn]

美 [kənˈtroʊl kənˈdɪʃn]

网络  控制条件; 控制状态; 控制环境

英英释义

noun

• a standard against which other conditions can be compared in a scientific experiment
  1. the control condition was inappropriate for the conclusions he wished to draw
  Synonym:control

双语例句

• The simulation results show, this system not only accord with characteristic demand from target tracking, but can effectively depress the interference with system load and better meet the control condition of jointed robots.
  仿真结果表明，该系统既可满足对目标跟踪的品质要求，又可对系统的负载干扰进行有效的抑制，能够较好地满足并联机器人的控制要求。
• Urban Road Network Model and Assignment Algorithm Analysis under Traffic Control Condition
  交通管制条件下城市道路网络模型及分配算法研究
• Hand picking, hand selection, ferment under temperature control condition to extract the noble of fruit essence, aging in oak barrel.
  人工采摘，人工分选，控温发酵，以完美体现葡萄品种的高贵特性，橡木桶陈酿。
• Factors influencing the particle size of Glauber ′ s salt is analyzed and the optimum process control condition is proposed.
  文章分析了在元明粉生产过程中，影响产品粒径大小的因素，提出了最佳的工艺控制条件。
• Slope stabilization is chief control condition in foundation issue.
  边坡稳定是土工问题的首要控制条件。
• The grade of conjunctival squamous metaplasia, the conjunctival goblet cell density and the score of FL were significantly related to the control condition of DM.
  杯状细胞密度和结膜上皮细胞鳞状化程度与糖尿病患者血糖控制情况呈显著性相关。
• The procedure that is varied in order to estimate a variable's effect by comparison with a control condition.
  通过对照可控制的情形来估计易变的影响的各式各样的程序。
• Study was made on the characteristics and control condition of short-cut nitrification in SBR at low DO, and the effect of carbon source concentration and dosing mode on efficiency of simultaneous denitrification.
  研究了低溶解氧下序批式反应器（SBR）的短程硝化特征和控制条件以及碳源浓度、投加方式对同步脱氮效率的影响。
• Driving system of electric vehicle based on DTC is researched according to the actual control condition of the electric vehicle.
  针对电动汽车实际控制条件，提出了电动汽车直接转矩控制系统的实现方案。
• There are new analytical and calculating methods of the varying pitch screw for rational design as well as control condition of transported containers or workpieces in stable motion.
  其中包括：合理设计变螺距螺杆的新的分析计算方法，以及被供送物件或容器实现稳定运动的可控条件。